Winnebago 1987-1989 LeSharo Service Manual page 640

ELECTRICAL CHECK
ELECTRICAL CHECK PROCEDURE
"\
NDITION
POSSIBLE CAUSE REMEDY
Light OFF, all terminals
None,
system O.K.
lead to each terminal of connector in-
Test light ON at terminals 5,7, and' 4
Red fused wire connected to wrong power
source, Use a "switched" power source at
fuse block. Test light should be "ON" when ig· nitlon switch is "ON" and "OFF" when ignition
switch is "OFF"
Test light ON at terminals 5, 7, and 14
None system OK
only
dividually,
No light on any terminal Replace fuse, it blown Connect red wire to Ig·
nition switched power source
Test light OFF at terminal 14.
None, system OK
See Trouble Shooting GUide - Control
Test light ON at terminal 14.
Switch.
Test light ON at terminal 10 and 14. None, system OK
hold. Slide switch to RESUME while
No light at terminal 10 and/or 14 See Trouble Shooting GUIde - Control
Switch.
Ignition Switch ON Control Switch ON.
Test light ON; push brake and test light
None, system OK
goes OFF.
Test light OFF
Adjust
disengagement switch(s) plunger
travel to get test light ON: OFF when brake or
I
clutch pedal is pushed.
A.
A test Iight or volt-ohmeter is needed to
perform these checks. If you have neither, a test
light can be made as shown.
Solder Two Places
12 Volt Bulb
G.E.53
or Equlv.
HOMEMADE TEST LIGHT
Leads Approx,
12" Long
;:;: ~f
=::;;;;:;;;:_~ __
;:;JS
I
i
'., -.J
1
I
B. A Speed Control System Tester is available which
will quickly indicate any problem area. The
Dana part number is 250·3122. More
information is given on pages 01-11 and 01-12.
If attaching the connector to the tester, the dark
green wire and Light NO.1 are at the same end.
02-6
Dark Green to
Tenminal 14
Smaller Terminal Numbers
Are Mounted on This Surface