Winnebago 1987-1989 LeSharo Service Manual page 453

REBUILD
FINAL ASSEMBLY
NOTE: The lip seal must be replaced each time the
shift shaft is removed, since it is unavoidably
damaged as the shaft is taken out.
80
,
"]
1
• Fit the lip seal (oiled).
• Ensure that there are no burrs on the shaft to
avoid damaging the lip on the seal.
• Refit the ring (if there is one).
• Placethe reverse lever (80) in position with its boss
towards the outside and clip it to the shaft.
• Oil the shaft and fit it together with its boot
(when applicable).
Assemble:
• The selector lever (82).
• The bushing (83) and the spring (84).
• The half shells (85) using tool B.Vi. 747
• Pin the selector lever (82) in place.
• Ensure that the pins are installed facing the right
direction.
G3-43