STUB AXLE CARRIERS
CHANGING THE BEARINGS
If it becomes necessary to replace a front
axle
bearing
or change a driveshaft,
the following
procedures MUST be followed
during reinstallation
to ensure the proper performance and longevity of
the replacement bearings.
1. Apply shaft sealer (Loctite® 680 High Strength)
(Winnebago Part number 076062-01-700), per
manufacturer's instructions, onto the center 1.3
of the inside hub grooves (See Diagram). Do not
use any other
form
of
Loctite@ for
this
operation.
as it will
not
meet the require
specifications. Be careful
not to apply shaft
sealer onto the surrounding
parts.
2. When reinstalling the assembly, always replace
the driveshaft washer (Winnebago Part Number
R79030-S3-143)and the driveshaft nut (Included
in Front Bearing Kit - Left or Right - Winnebago
Part Number R77014-62-021).
3. Torque tighten the driveshaft nut to 20 daNm
(147 Ib.lft.)
Apply Loctite to this area
Nut
Washer
J4-S
11
,
I
.•. J
I
\
)
1