ENGINE OVERHAUL
&
REBUILD
ENGINE DISASSEMBLY
REMOVE OR DISCONNECT
• Oil pump
• Crankshaft timing sprocket
• Position sprocket removal tool B.Vi. 28-01 (with
shaft end protector tool Rou. 15-01) with the jaws
inserted behind the spacer (1).
• Pull the spacer (1) and sprocket (2) forward from
the crankshaft until the spacer stops at the key (3).
• Do not force the spacer beyond this position.
• Remove the tools, then install them with the jaws
inserted between the spacer (1) and the sprocket
(2).
• Pull the sprocket (2) from the crankshaft.
NOTE: If there is not enough space between the
spacer (1) and the sprocket (2) to insert the
tool jaws, insert 2 mm (0.078 in) metal strips
between the washer and sprocket. Insert the
jaws behind the washer and pull the spacer
and sprocket from the crankshaft until the
washer stops at the key.
83-6
f
L