PART REPLACEMENT
PILLAR LINING
STIFFENER
PREPARATION
Cut a section out of new stiffener which is about 50
mm (2") longer than the section it is to replace.
Saw cut the new section along corners (D) for 60 mm
(2 1/2") so that it overlaps.
Drill a series of 6 mm dia. holes for plug welding the
overlapping section.
/~
\
\
REFiniNG
Mount and align the new stiffener section so that it
overlaps the section remaining in place.
Spotweld the following
joints:
-C : stiffener and pillar lining.
MIG plugweld:
-E : the holes in the new section
MIG seam weld:
-D : the 2 corners (D) and the end of the new section
where it overlaps.
P1-34
E
I,
~
\
\
\
.
'
./
)
~.~