DRIVE SHAFTS
OVERHAULING
(LOBRO 6-BALL
COUPLING)
DISASSEMBLING
- Slide onto the shaft:
rubber collar (A)
- boot (3)
Slide the ball coupling complete with retaining
ring onto the shaft splines until the retaining ring
locates in shaft groove (B).
I
/
~
2
78 614
- Spread the grease (140 g.) around inside the boot.
- Locate the lips of the boot in the grooves in
bell-shaped stub axle (1) and in drive shaft (2).
..
200
000"
.1
- Mount the retaining clips over the boot with 2
short lengths of tube.
J8-9