Power Steering Pump - Winnebago 1987-1989 LeSharo Service Manual

POWER STEERING
HOSE REPLACEMENT
I
f
B
U-Bolt
Pump
Figure 1 - Attach Hose to Bracket
REMOVAL
- Remove steering hose bracket bolts (A) and hose
pipe nut (B) to access U-bolt nuts.
- Remove U-bolt and remove steering hose from
bracket.
REINSTALLATION
1. Attach the hose to the bracket with the U-bolt
and lock nuts. The U-bolt should seat into the
groove around the hose collar as shown. Run the
lock nuts up to the bracket but DO NOT
TIGHTEN. The hose must be able to move until
the assembly is mounted to the pump.
2. Reinstall the bracket with bolts (A) and finger
tighten only.
3. Install the hose elbow with pipe nut into the
pump outlet but DO NOT TIGHTEN.
4. Tighten the lock nuts on the U-bolt, making sure
that the hose pipe nut (B) does not bind after
the U-bolt is tightened. If so, loosen the U-bolt
and reposition the hose slightly. Then retighten
the U-bolt, making sure again that the pipe nut
turns freely.
5. Tighten the pipe nut to 10 ft.llb. (14 Nm .±. 2).
Then tighten the bracket/pump mounting bolts
(A).
6. Check power steering fluid level and add as
necessary.
NOTE: If the vehicle is not equipped with a steering
hose bracket, see Winnebago Service Bulletin A
01-89-0SG. (See your dealer.)
Figure 2 - Attach Bracket to Pump Mount
J6-1