Water Pump - Winnebago PASEO 48P User Manual

SECTION 7 –
PLUMBING
Method 2 - Filling the Fresh Water
Tank Through Gravity Fill
WA RNING
Potable water only.
Sanitize, flush, and drain water tank
before using.
See owner's manual for instructions,
care, and maintenance information.
Failure to maintain tank can result in
death or serious injury.
Always fill the fresh water tank at an approved
potable water filling facility or a known purified
drinking water source.
The gravity tank fill is located beneath
passenger side dinette seat, remove cushion to
access.
Water Tank Gravity Fill
(Located beneath passenger side dinette seat,
remove cushion to access)
-Typical View
• Remove plug from top of tank.
• Insert hose into fill opening and turn water
supply on. Tank is full when water flows from
the tank vent tube beneath coach.
7-2
Using Tank Water (Gravity Fill)
• Turn Water Pump switch ON. While the
switch is on, the water pump will
automatically supply tank water as needed.
Connecting City Water Supply
City Fill Inlet
(Located on the left sidewall)
-Typical View
When connected to an outside source of water,
the water bypasses the water pump and storage
tank and supplies pressure directly to individual
faucets and toilet. A check valve built into the
pump prevents water from entering the pump and
filling the storage tank.
• Connect hose to City Fill Inlet.
Disconnecting from City Water
• Turn the city water supply OFF.
• Open a faucet on the coach (such as the
exterior wash station, if equipped) to relieve
line pressure.
• Disconnect hose from the coach and replace
cap on the City Fill Inlet.

WATER PUMP

When your coach is not connected to a city
water supply, water is supplied from the fresh
water tank by a water system demand pump. A
demand pump is designed to run only when you
are using water. When you open a faucet, the
waterline pressure drops and the pump begins to
run, and it will continue to run as long as the