DRIVE SHAFTS
OVERHAULING (SPIDER G182 COUPLING)
These operations may be carried out on this type of
coupling:
- boot change
- spider gear change
- and a yoke change
The disassembly method is the same for all three
operations. The method of reassembly differs for the
yoke as the sheet metal cover must be crimped in
place.
1. Yoke
2. Cover
3. Spider gear
4. Seal
S. Retaining clip
6. Rubber boot
7. Retaining ring
8.
Drive shaft
DISMANTLING
• Place adhesive tape or the protective cap (supplied
with new drive shaft) on the bearing surface for
the differential
nut oil seal.
• Cut the crimped clip and the boot along its full
length.
• Remove as much grease as possible.
J8-3