REAR AXLE AND SPRING ASSEMBLY
REMOVE AND REPLACE
TIGHTENING TORQUES
Spring front and rear trunnion
bolts
(10 daNm 74 Ib.lft.)
.r;
Shock absorber top mounting nuts
1.5 daNm (11 Ib.lft.)
,
REMOVAL
- Place the rear of the vehicle on stands. From inside
the vehicle,
remove the shock absorber
top
mounting nuts.
Remove the rear spring trunnion
mounting
bolt
nuts and the shock absorber bottom
mounting
nuts.
Disconnect
the
brake
hose and
hand brake
secondary cables.
Using a jack under the axle beam, take its weight
so that the front trunnion bolts may be removed.
Lower the jack and free the limiter control.
Remove rear blade clips (1)
Withdraw
the complete assembly.
REASSEMBLY
- With the rear of the vehicle on stands, lift up the
rear axle assembly and insert the trunnion bolts at
the front of the rear springs. Remember to mount
the limiter control in its bearing.
- Using a jack under the axle beam, take its weight
and mount the rear trunnion
bolts.
I
- the handbrake
- brake hose
- shock absorbers at their top mountings
- lower the vehicle onto its wheels and fasten the
shock absorber bottom mountings.
- torque
tighten
all the trunnion
bolt nuts and
bleed the brake circuit.
!
K4·1