Show Ip Access-Lists - NETGEAR GSM7224v2 - Layer 2 Managed Gigabit Switch Cli Manual

no ip access-group
This command removes a specified IP ACL from an interface.
Default none
Format
no ip access-group <accesslistnumber> [vlan <vlan-id>] in
Mode • Interface Config
• Global Config
acl-trapflags
This command enables the ACL trap mode.
Default disabled
Format
acl-trapflags
Mode Global Config
no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode Global Config

show ip access-lists

This command displays an IP ACL <accesslistnumber> is the number used to identify the
IP ACL.
Format
show ip access-lists <accesslistnumber>
Mode Privileged EXEC
Note: Only the access list fields that you configure are displayed.
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-42