Tray Heater - Gestetner A193 Service Manual

COPIER INSTALLATION

2.10 TRAY HEATER

û
CAUTION
Unplug the copier power cord before starting the following procedure.
1. Remove the 2nd paper feed tray.
2. Install the clamp [A] on the base. Then, install the tray heater [B] (1
screw).
3. Connect the connector [C] of the heater to the copier's connector [D],
which is on the rear frame.
4. Reassemble the machine.
5. Check the printer side-to-side registration (2nd paper tray).
NOTE: Instruct the customer that even when the copier's main switch is
turned off, the copier power cord should be plugged in.
Otherwise, the tray heater will not function.
(A193)
[B]
[A]
3-22
[C]
A193I507.wmf
SM