Table of Contents
Advertisement
DETAILED DESCRIPTIONS
2.5 FEED OUT MECHANISM
[C]
[B]
[A]
[D]
After the copies have been stapled, the feed-out motor [A] will turn on to drive
the feed out belts. The stack stoppers [B] on the feed-out belt transports the
set of stapled copies upward,(speed 450 mm/s) and will feed the copies
towards the shift tray. Approximately 500 ms after the feed-out motor had
turned on, the motor will stop for 500 ms. At this moment, the exit roller [C]
will catch the stapled copies to feed them out and onto the shift tray. Then,
the feed-out motor will turn on again until the stack stopper activates the
feed-out belt home position sensor [D].
The transport motor drives the brush roller and the exit roller [C] (speed 500
mm/s). The transport motor will turn on when the feed-out motor turns on, at
the start of feed-out, to drive the brush roller. This will prevent the brush roller
from disturbing the smooth upward passage of the leading edge of the copy
set at the start of paper feed. After 200 ms, the transport motor will turn off
and then turn on again in the reverse direction to feed out the set of stapled
copies.
SM
12-10
(A666)
Advertisement
Chapters
Table of Contents
