Gestetner A193 Service Manual page 589

NOTE: For European models only, perform steps a, b, and c.
a. Remove bracket [a], from the fax unit.
b. Remove screw [b] and install bracket [C] as shown.
3. Remove the inner bracket [F] (2 screws).
4. Turn on the battery switch [G]. Install the fax unit [H] (4 screws), as shown.
Caution: Use extreme care opening and closing the connector latch to
prevent damaging the latch. Gently open the connector latch
and insert the flat cable. Ensure that the cable is properly
inserted before closing the latch.
5. Connect the flat harness [I] to the BiCU (CN304), and connect the
harness [J] to the PSU (CN288).
c. Replace bracket [a] which was removed in step [a]; and install small
bracket [d]
NOTE: Use a magnetic screwdriver to ensure that screws are not dropped inside the
machine.
6. Replace the rear cover (5 screws).
7. Remove the parts [K], [L], and [M] from the operation panel.
8. Peel off the decal [N] as shown, then remove part [O].
9. Install each part, [P], [Q] and [R] on the operation panel, as shown.
10. If the machine has the printer controller option, install the keys [S] and the
decal [T] as shown. The decal [T] has "Copy," "Printer," and "Facsimile"
printed on it.
If the machine does not have the printer controller option, install the
keys [U] and the decal [V] as shown. The decal [V] has "Copy" and
"Facsimile" printed on it
(A639) 3-3
FAX UNIT
SM