Gestetner A193 Service Manual page 146

[C]
[A]
[D]
10. Unscrew the bottle cap [A] and insert the bottle into the holder [B] position
the rear tab upward.
NOTE: Do not remove the inner bottle cap [C].
11. Reposition the holder and press down the holder lever [D] to secure the
bottle.
12. Install the optional platen cover if required:
1) Install two stud screws on the top cover.
2) Position the platen cover bracket on the stud screws and slide the
platen cover to the left secure with 2 screws.
13. Pull the paper tray [E] out and turn the paper size dial [F] to select the
appropriate size. Adjust the side guides [G] and end guide [H] to match
the paper size.
14. Turn both the ac and main switches on. The machine automatically
performs TD (Toner Density) sensor initial setting. Then, check the copy
quality and copying functions.
NOTE: Do not turn the ac and main switches off or open any covers
during the TD sensor initial setting.
SM
[B]
A193I504.wmf
[E]
[F]
3-7
COPIER INSTALLATION
[H]
[G]
A193I505.wmf
(A193)