Gestetner A193 Service Manual page 392

REPLACEMENT AND ADJUSTMENT
5.4 FEED BELT REPLACEMENT
[C]
[B]
[C]
[A]
1. Remove the original feed unit.
2. Remove the front bushing [A], spring [B], and washers [C] (2 E-ring).
3. Remove the original guide [D] (1 E-ring).
4. Remove the snap ring [E] and the pick-up roller unit [F].
5. Release the idle roller holder [G] from the drive roller shaft.
6. Remove the idle roller [H], idle roller holder [G], and 2 springs [I].
7. Replace the feed belt [J].
(A661)
[E]
[D]
[G]
[J]
11-26
[F]
[I]
[H]
[I]
[G]
SM