Replacement And Adjustment; Feed Roller And Friction Pad; Removing The Paper Tray Unit From The Copier; If Optional Tray Heater Is Not Installed - Gestetner B130 Service Manual

FEED ROLLER AND FRICTION PAD

2. REPLACEMENT AND ADJUSTMENT

2.1 FEED ROLLER AND FRICTION PAD
1. Take the tray out of the paper tray
unit.
2. Clip ring [A]
3. Shaft assembly [B]
4. Feed roller [C] (! x 1)
5. Friction pad [D]
2.2 REMOVING THE
PAPER TRAY UNIT FROM THE COPIER

If Optional Tray Heater Is Not Installed

1. Lift the copier off of the paper tray unit.

If Optional Tray Heater Is Installed

1. Refer to Section 1.4.2 of the B044/B045/B046 Service Manual, and carry out
the following steps of that procedure in this order:
• Step 2 (remove both paper trays)
• Step 7 (remove copy tray)
• Step 8 (remove rear cover)
• Step 9 (remove FCU cover plate)
2. Refer to Section 1.4.2 of the B044/B045/B046 Service Manual, and do the
following:
• Unscrew the ground line.
• Unclamp the heater harness clamps.
• Disconnect the heater harness from the relay harness.
• Unwrap and remove the core.
3. Pull the relay harness down and out through the hole in the PSU bracket, and
then pull it all the way in through the hole at the rear of the (main) paper tray
unit.
4. Remove the 3 screws fastening the paper tray unit to the copier (☛ 1.4.2 of the
B044/B045/B046 Service Manual, Step 6).
5. Lift the copier off the paper tray unit.
To reinstall, refer to the procedure in Section 1.4.2 of the B044/B045/B046
Service Manual. Carry out most of that procedure, starting from Step 5
and omitting unnecessary steps.
B421
CÓPIA NÃO CONTROLADA
6
CÓPIA NÃO CONTROLADA
[C]
[A]
B421R101.WMF
[B]
[D]
SM