Service Tables And Procedure - Gestetner A193 Service Manual

4. SERVICE TABLES AND PROCEDURE

4.1 BIT SWITCHES
This section describes only the updated switches. The updated bits of the
switches are marked with an asterisk.
4.1.1 System Switch
System Switch 1F (Bit 2 has been defined.)
No FUNCTION
0 Not used
1
2* Printing a report after a jam
or memory overflow occurred
during memory tx
0: Enabled
1: Disabled
3 Received fax print start timing
(G3 reception)
0: After receiving each page
1: After receiving all pages
4 Received fax print start timing
(G4 reception)
0: After receiving each page
1: After receiving all pages
5 Not used
6
7 Action when a fax SC has
occurred
0: Automatic reset
1: SC code display
SM
SERVICE TABLES AND PROCEDURE
COMMENTS
Do not change the settings.
0: The machine prints a Memory Storage Report
(Memory Tx) or a Transmission Result Report, if a jam
or memory overflow occurred while storing a document
into memory.
1: The machine does not print a report in the above
conditions.
0: The machine prints each page immediately after the
machine receives it.
1: The machine prints the complete message after the
machine receives all of the pages in the memory.
Do not change the factory settings.
0: When the fax unit detects a fax SC code other than
SC1201 and SC1701, the fax unit automatically reset
itself.
1: When the fax unit detects any fax SC code, the fax
unit displays the SC code and stop.
Cross Reference
Fax SC codes - See "Troubleshooting"
7-21 (A804)