Stamp - Gestetner A193 Service Manual

DETAILED DESCRIPTIONS

3.4 STAMP

[C]
[A]
[B]
A628O505.wmf
This function is only for fax mode only.
There is a stamp [A] located between the 2nd transport roller [B] and the exit
roller [C], and its solenoid is controlled by the copier directly.
When the original reaches the stamp position, the DF feed motor stops. At
300 milliseconds after stopping the DF feed motor, the stamper solenoid
turns on if the page was sent successfully (immediate transmission) or stored
successfully (memory transmission). After stamping, the DF feed motor turns
on again to feed out the document, and its speed is about 1.3 times the
normal speed.
The stamping position on the original can be changed by adjusting SP6-010.
(A628) 7-10 SM