Gestetner A193 Service Manual page 595

2.2 INITIAL PROGRAMMING
Key-operator Level
Own ISDN - G4 number
G4_TID ( Terminal ID )
ISDN - G3 CSI
Own ISDN - G3 number
Service Level
CiG4 Country Code (G4 Internal SW 00)
ISDN international prefix
Own ISDN-G4 number main/sub
Own ISDN-G3 number main/sub
G4 subaddress
ISDN-G3 subaddress
Line used for G3 transmission
(System switch 0A- bit 6)
Line used when the machine falls
back to G3 from G4 (if the other
machine is not a G4 machine)
(System switch 0A- bit 7)
NOTE: 1. After changing any parameter, be sure to turn off the ac and
main switches, wait 5 or more seconds, then turn them back on.
This ensures the new settings will take effect.
2. Print the G4 system parameter list and make sure all parameters
just programmed are listed.
(A639)
Key-operator mode 16
Key-operator mode 16
Key-operator mode 15
Key-operator mode 15
Service mode 01
Service mode 12-1
Service mode 12-2, 3
Service mode 12-4, 5
Service mode 12-6
Service mode 12-7
Service mode 01 - 1
Service mode 01 - 1
3-9
ISDN G4 UNIT
SM