Gestetner A193 Service Manual page 650

Table of Contents

Advertisement

BIT SWITCHES
Communication Switch 14
No
FUNCTION
0 Inch-to-mm conversion
during transmission
0: Disabled
1: Enabled
1
Not used
to
5
6
Available unit of resolution in
which fax messages are
7
received
Bit 7 Bit 6
Unit
0
0
mm
0
1
inch
1
0
mm and inch
(default)
1
1
Not used
Communication Switch 15 - Not used (do not change the settings)
Communication Switch 16 - Not used (do not change the settings)
Communication Switch 17 - Not used (do not change the settings)
Communication Switch 18 - Not used (do not change the settings)
Communication Switch 19 - Not used (do not change the settings)
Communication Switch 1A - Not used (do not change the settings)
Communication Switch 1B - Not used (do not change the settings)
Communication Switch 1C - Not used (do not change the settings)
Communication Switch 1D - Not used (do not change the settings)
Communication Switch 1E - Not used (do not change the settings)
Communication Switch 1F - Not used (do not change the settings)
SM
0: In immediate transmission, data scanned in inch
format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data into mm
format.
1: The machine converts the scanned data or stored
data in the SAF memory to the format which was
specified in the set-up protocol (DIS/NSF) before
transmission.
Do not change the factory settings.
For the best performance, do not change the factory
settings.
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol
exchange (in the DIS/NSF frames).
4-46
COMMENTS
(A639)

Advertisement

Table of Contents
loading

This manual is also suitable for:

A224

Table of Contents