Gestetner A193 Service Manual page 697

Code Meaning
5-22 Mode table overflow after
the second page of a
scanned document
5-23 Print data error when
printing a substitute rx or
confidential rx message
5-24 Memory overflow after the
second page of a scanned
document
5-25 SAF file access error
5-30 Mode table for the first
page to be printed was not
effective
6-01 G3 ECM - no V.21 signal
was received
6-02 G3 ECM - EOR was
received
6-03 G3 ECM - non-standard
V.21 code received
6-04 G3 ECM - RTC not
detected
6-05 G3 ECM - facsimile data
frame not received within
18 seconds of CFR, but
there was no line fail
6-06 G3 ECM -
coding/decoding error
6-08 G3 ECM - PIP/PIN
received in reply to
PPS.NULL
6-09 G3 ECM - ERR received
6-10 G3 ECM - error frames
still received at the other
end after all
communication attempts
at 2400 bps
6-11 G3 ECM - printing
impossible because of a
missing first line in the
MMR coding
Suggested Cause/Action
Wait for the messages which are currently in the
memory to be sent or delete some files from memory.
Test the SAF memory.
Ask the other end to resend the message.
Replace the FCU or IC memory card.
Try using a lower resolution setting.
Wait for the messages which are currently in the
memory to be sent or delete some files from memory.
Replace the FCU, the IC memory card, or the hard
disk.
Replace the FCU, the IC memory card, the function
upgrade card, or the hard disk.
Try adjusting the rx cable equalizer.
Replace the FCU or NCU.
The other terminal may be defective.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the tx levels of the communicating machines.
See code 6-05.
Check for line noise.
Adjust the tx level (use NCU parameter 01 or the
dedicated tx parameter for that address).
Check the line connection.
Defective remote terminal.
Check for problems in the printer mechanism.
6-5
ERROR CODES