Gestetner A193 Service Manual page 806

3.3 HARD DISK DRIVE
[A]
NOTE: If the printer controller is already installed, remove the printer
controller to install the hard disk drive.
1. Attach the bracket [A] to the hard disk drive [B] (4 screws).
2. Attach the hard disk drive assembly to the controller board [C] (3 screws).
3. Connect the flat cable connector [D] from the hard disk drive assembly to
the controller board.
NOTE:Two of the holes on one end of the cable connector are filled with
pins. Connect this end of the cable to the Hard Disk Drive.
4. Install the printer controller assembly along the guides (see 3.1. Printer
Controller).
5. Replace the interface cover (see 3.1. Printer Controller).
SM
[B]
[D]
[C]
1-17
A643I503.wmf
(A643)