Gestetner A193 Service Manual page 728

SERVICE TABLES AND PROCEDURE
4.1.2 Printer Switch
Printer Switch 0E (Bit 3 has been defined additionally)
No FUNCTION
0 Paper size selection priority
0: Width
1: Length
1 Paper size selected for
printing A4 width fax data
0: 8 x 11" size
1: A4 size
2 Page separation
0: Enabled
1: Disabled
3* Type of image printed on
reports
0: Upper half
1: 50% reduction
4 Not used
to
6
7 Equalizing the reduction rate
among separated pages
(Page Separation)
0: Enabled
1: Disabled
4.2 RAM ADDRESSES
4800AA(H) - User parameter switch 10 (SWUSR_0A)
Bit 0: Not used
Bit 1: 2 into 1
Bit 2*: Paper selection priority for A4 documents
Bit 3: Page reduction
Bits 4 to 7: Not used
(A804)
0: A paper size which has the same width as the
received data is selected first.
1: A paper size which has enough length to print all the
received lines without reduction is selected first.
This switch determines which paper size is selected for
printing A4 width fax data, when the machine has A4
and 8" x 11" size paper at the same time.
1: If all paper sizes in the machine require page
separation to print a received fax message, the machine
will not print the message (Substitute Reception is used).
After a larger size of paper is set in a cassette, the
machine will automatically print the fax message.
0: The upper half of the image is printed on the reports
unreduced.
1: The image is printed reduced by 50% in the sub-scan
direction.
Note: Even if "50% reduction" is selected, the transfer
result report will have the upper half of the image
unreduced.
Do not change the settings.
0: All the pages are reduced with the same reduction
ratio, when page separation has taken place.
1: Only the last page is reduced to fit the selected paper
size when the page separation has taken place. Other
pages are printed without reduction.
0: Off, 1: On
0: Off, 1: On
7-22
COMMENTS
0: A3, 1: B4
SM