Table of Contents
Advertisement
Rev. 10/2000
⇒
3.4.3 INSTALLATION PROCEDURE FOR THE TRAY HEATER KIT
(OPTIONAL)
1. Remove the LCT unit from the main copier and remove the LCT right cover.
2. Attach the two anti-condensation heaters [A and B] (2 screws each) to the LCT
bottom plate.
3. Attach the heater cover [C] (2 screws).
4. Attach the two harness clamps [D] to the LCT bottom plate as shown.
5. Run the heater harnesses [E and F] through the harness clamps. Insert the
connectors into the connector bracket holes shown below.
6. Connect the interface harness connectors [G and H] to the connectors that
were just inserted into the connector bracket holes (step 5).
SM
CÓPIA NÃO CONTROLADA
3-19B
3-3
CÓPIA NÃO CONTROLADA
LCT INSTALLATION (B303)
A294/A295
Advertisement
Table of Contents
Troubleshooting
