Gestetner A193 Service Manual page 673

4800A4(H) - User parameter switch 04 (SWUSR_04: Automatic report printout)
Bit 0: Automatic confidential reception report output
Bits 1 to 6: Not used
Bit 7: Inclusion of a sample image on reports
4800A5(H) - User parameter switch 05 (SWUSR_05)
Bit 0: Substitute reception when the base copier is in SC condition
Bits 1 and 2: Condition for substitute rx when the machine cannot print messages (Paper
end, Toner end, and Jam in 3.5W energy saver mode)
Bit 2 1 Setting
0 0 The machine receives all the fax messages
0 1 The machine receives the fax messages with RTI or CSI
1 0 The mahcine receives the fax messages with the same ID code
1 1 The machine does not receive anything.
Bit 3: Not used
Bit 4: Restricted Access using personal code
Bits 5 to 7: Not used
4800A6(H) - User parameter switch 06 (SWUSR_06)
Bit 0: Not used
Bit 1: G3/G4 LED home position
Bit 2 to 7: Not used
4800A7(H) - User parameter switch 07 (SWUSR_07)
Bits 0 and 1: Not used
Bit 2: Parallel memory transmission
Bits 3 and 7: Not used
4800A8(H) - User parameter switch 08 (SWUSR_08)
Bit 0 and 1: Not used.
Bit 2: Authorized reception
0: Only faxes from senders whose RTIs/CSIs are specified for this feature are accepted.
1: Only faxes from senders whose RTIs/CSIs are not specified for this feature are accepted.
Bits 3 to 7: Not used.
4800A9(H) - User parameter switch 09 (SWUSR_09)
Bits 0 to 7: Not used
4800AA(H) - User parameter switch 10 (SWUSR_0A)
Bit 0: Not used
Bit 1: 2 into 1
Bit 2: Not used
Bit 3: Page reduction
Bits 4 to 7: Not used
4800AB(H) - User parameter switch 11 (SWUSR_0B)
Bit 0: Not used
Bit 1: Method of transmitting numbers after the "Tone" mark over an ISDN line
0: UUI, 1: Tone
Bits 2 to 5: Not used
Bit 6: Printout of messages received while acting as a forwarding station 0: Off, 1: On
Bit 7: Polling Standby duration
(A639)
0: G3, 1: G4
0: Off, 1: On
0: Off, 1: On
0: Once, 1: No limit
4-69
SERVICE RAM ADDRESSES
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
SM