Gestetner A193 Service Manual page 590

FAX UNIT
11. Install the Stamper [W] into the ADF as shown.
12. Plug in the machine and turn on the ac and main switches.
13. Press the 'Facsimile' key and check that the
facsimile LED lights. At this time, the
following message should be shown:
NOTE: This is not a functional problem. The machine shows this message
only when the fax unit is installed for the first time.
14. Press "Yes" to initialize the fax unit.
15. Connect the telephone cable to the "LINE" jack at the rear of the machine.
16. Set up and program the items required for fax communications, as shown below.
If the user function keys (F1, F2, F3 and F4) need to be programmed, affix the
enclosed label above the function keys.
The default settings of the user function keys are as follows:
F1 - Start Manual Rx
F2 - TEL Mode
F3 - Tx Result Display
F4 - Not programmed
17. (US only) If the optional handset needs to be installed, refer to section 4
'HANDSET' for the installation procedure.
SM
[W]
3-4
A194I523.wmf
A194I520.img
(A639)