Gestetner A193 Service Manual page 385

3. INSTALLATION
[A]
[B]
[F]
+
CAUTION
Unplug the copier power cord before starting the following procedure.
NOTE: When installing the DF, use the tool [A] in the accessory bag or a
usual screw driver.
1. Unplug the document feeder. Then, remove all tapes.
2. Remove the left scale [B] (2 screws).
3. Place the DF exposure glass [C] on the glass holder. The white mark [D]
must be at the rear side facing down.
4. Peel off the backing [E] of the double side tape attached to the rear side of
the scale guide [F], then install the scale guide (2 screws removed in step 2).
5. Affix the original size decal [G] on the scale guide.
NOTE: Place the decal along the rear edge, and the left side of the decal
is flush with the scale paper guide [H], as shown.
6. Install the stud screws [I] and the grounding plate [J] for the DF on the
copier.
SM
[H]
[E]
[C]
11-19
INSTALLATION
[D]
[G]
[I]
[J]
[I]
(A661)