Hard Disk (Function); Service Station Fax Number (Function) - Gestetner A193 Service Manual

SERVICE LEVEL FUNCTIONS
To initialize the fax unit without erasing files or resetting the swicthes, perform
one of the following:
•
Press the "Facsimile" key and make sure the Facsimile LED is on. Then,
hold down the "Speed Dial" key for more than 10 seconds.
•
Turn off the main and ac switches and turn them back on.
•
Remove the rear cover, and press SW2 on the FCU.
1.13 HARD DISK (FUNCTION 08)
NOTE: To access this function, the hard disk option must be installed,
and System Switch 05, bit 4 must be set to 1.
1. Enter the fax service mode.
 
2. Press
3. Press one of the following numbers, as

required, then press
Erases everything stored on the
–
hard disk

Low level hard disk formatting
–
(requires over 45 min.)
NOTE: If there is an error during the test, the machine displays 'NG'.
4. Make sure that "OK" is displayed after
the process, then exit the service mode.
1.14 SERVICE STATION FAX NUMBER (FUNCTION 09)
1. Enter the fax service mode.
 
2. Press
3. Enter the fax number of the service
station that will receive Automatic
Service Calls from this machine. To use
a G4 number, press the 'F4' key.
4. Press OK.
5. Exit the service mode.
SM

.
4-8
A194M519.img
A194M520.img
(A639)