Gestetner A193 Service Manual page 724

INSTALLATION
[W]
11. Install the Stamper [W] into the ADF as shown.
12. Open the bypass feeder and attach the enclosed serial number label on
the metal frame.
13. Plug in the machine and turn on the ac and main switches.
14. Press the 'Facsimile' key and check that the
facsimile LED lights. At this time, the
following message should be shown:
NOTE: 1) This is not a functional problem. The machine will show this
message only when the fax unit is installed for the first time.
2) If "SC681" is shown on the display instead of "SC1201", the old
type of fax unit was installed in the A224 copier. Refer to section
5.1 for details.
15. Press "Yes" to initialize the fax unit.
16. Connect the telephone cable to the "LINE" jack at the rear of the machine.
17. Set up and program the items required for fax communications, as shown below.
If the user function keys (F1, F2, F3 and F4) need to be programmed, affix the
enclosed label above the function keys.
The default settings of the user function keys are as follows:
F1 - Start Manual Rx
F2 - TEL Mode
F3 - Tx Result Display
F4 - Not programmed
(A804) 7-18
A804I523.wmf
A804I520.img
SM