Printer Enhancement Unit - Gestetner A193 Service Manual

3.2 PRINTER ENHANCEMENT UNIT

NOTE: If the printer controller is already installed, remove the printer
controller to install the printer enhancement unit option.
1. Remove the bracket [A] (2 screws).
2. Connect the printer enhancement unit [B] (2 connectors).
3. Remove the two short pins [C] from JP2 and JP3 on the printer controller
board.
4. Install the printer controller along the guides (4 screws). (See 3.1. Printer
Controller.)
5. Replace the interface cover (3 screws). (See 3.1. Printer Controller.)
(A643)
[C]
[B]
[A]
1-16
A643I505.wmf
SM