Gestetner A193 Service Manual page 627

System Switch 04
No FUNCTION
5 Memory file transfer operation
0: Service level
1: User level
6 G3 CSI/G4 Terminal ID
programming level
0: User level
1: Service level
7 Telephone line type
programming mode
0: User level
1: Service level
System Switch 05
No FUNCTION
0 Not used
1
2 Display of both RTI and CSI
on the LCD
0: Disabled 1: Enabled
3 Not used
4 Hard disk option
0: Not installed
1: Installed
5 Not used
6
7
(A639)
COMMENTS
If the machine is unable to print fax messages due to a
mechanical problem, change this bit to 1 to transfer all
messages in the memory (including confidential rx
messages) to an another terminal.
Always reset this bit to zero after transfer. However, this
bit can be left at 1, only if the customer's key-operator
wants to transfer the files by himself.
Procedure
1. Enter the service mode and change this bit to 1.
2. Exit the service mode.
3. Enter the key-operator mode, and select
'Key-operator settings'.
4. Choose '03' and specify a destination for the machine
to transfer all the files to.
5. Press 'OK'.
6. After the machine transfers the memory files, enter
the service mode and reset this bit to 0.
Otherwise, anybody who knows how to enter the
key-operator mode can transfer confidential messages.
1: The CSI and Terminal ID can only be programmed
using a service function.
The Terminal ID can only be programmed if a Group 4
option is installed.
1: Telephone line type selection (tone dial or pulse dial)
can only be programmed using a service function.
COMMENTS
Do not change the settings.
1: An RTI will be displayed until phase B of the protocol
sequence, and a CSI will be displayed after phase C.
Do not change the settings.
Change this bit to 1 when installing the hard disk option.
Do not change the settings.
4-23
BIT SWITCHES
SM