Gestetner A193 Service Manual page 723

NOTE: For European and Asian models only, perform steps a, b, and c.
a. Remove bracket [a] from the fax unit.
b. Remove screw [b] and install bracket [c] as shown.
3. Remove the inner bracket [F] (2 screws).
4. Turn on the battery switch [G]. Install the fax unit [H] (4 screws), as shown.
CAUTION
Use extreme care opening and closing the connector latch to prevent
damaging the latch. Gently open the connector latch and insert the flat
cable. Ensure that the cable is properly inserted before closing the
latch.
5. Connect the flat harness [I] to the BiCU (CN304), and connect the
harness [J] to the PSU (CN288).
c. Replace bracket [a] which was removed in step [a]; and install small
brackets [d] and [e].
NOTE: Use a magnetic screwdriver to ensure that screws are not dropped inside the
machine.
6. Replace the rear cover (5 screws).
7. Remove the parts [K], [L], and [M] from the operation panel.
8. Peel off the decal [N] as shown, then remove part [O].
9. Install each part, [P], [Q] and [R] on the operation panel, as shown.
10. If the machine has the printer controller option, install the keys [S] and the
decal [T] as shown. The decal [T] has "Copy," "Printer," and "Facsimile"
printed on it.
If the machine does not have the printer controller option, install the
keys [U] and the decal [V] as shown. The decal [V] has "Copy" and
"Facsimile" printed on it.
SM 7-17
INSTALLATION
(A804)