Gestetner A193 Service Manual page 629

System Switch 0A
No FUNCTION
0 Not used
1
2
3 Continuous polling reception
0: Disabled 1: Enabled
4 Dialing on the ten-key pad
when the external telephone
is off-hook
0: Disabled 1: Enabled
5 On hook dial
0: Disabled 1: Enabled
6 Line used for G3 transmission
0: PSTN 1: ISDN
7 Line used when the machine
falls back to G3 from G4 if
the other end is not a G4
machine
0: PSTN 1: ISDN
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E
No FUNCTION
0 Not used
1
2
3 Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx
operation (the display
remains the same)
4 Not used
to
7
(A639)
COMMENTS
Do not change the settings.
This feature allows a series of stations to be polled in a
continuous cycle. This will continue until the polling
reception file is erased.
The dialing interval is the same as memory transmisison.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting when the
external telephone is not by the machine, or if a wireless
telephone is connected as an external telephone.
1: The user can dial on the machine's ten-key pad when
the handset is off-hook.
0: On hook dial is disabled.
If an ISDN unit has been installed, this bit determines
whether G3 transmissions go out over the PSTN or the
ISDN.
This bit switch has no effect if Communication Switch 07
bit 0 is set to 0.
COMMENTS
Do not change the settings.
0: Manual tx and rx are possible while the external
handset is off-hook. But, memory tx is not possible.
1: The display stays in standby mode even when the
external handset is used, so that other people can use
the machine for memory tx operation.
Note that manual tx and rx are not possible with this
setting.
Do not change the settings.
4-25
BIT SWITCHES
SM