Copier/Fax, Copier/Printer/Fax - Gestetner A193 Service Manual

ENERGY SAVER MODES

8.4 COPIER/FAX, COPIER/PRINTER/FAX

'
Stand-by Mode
Main
Switch
Off
Main
Switch
O n
Night Mode Level 1
Fusing Lamp Off
Energy Saver LED Off
SCP On (System 5V On)
Energy Saver CPU On
(5VE On)
Energy saver mode is more complex in this configuration. This is because
there are two night modes, instead of the auto shut off mode. Night mode
level 2 is similar to auto shut off mode. Night mode level 1 keeps the machine
in a slightly higher state of readiness (the main cpu is active and the system 5
volt supply is on, but the fusing lamp is still off).
Entering energy saver mode
The machine enters energy saver level 1 or 2 in the same way as the copier
only and copier/printer configurations.
(A193)
Clear Mode/Energy Saver Key
System Auto Reset Timer
Clear Mode/Energy Saver Key
Original in the DF
DF lifted up
Ringing signal detected
NCU off hook (start of dialing)
Clear Mode/Energy Saver Key
Original in the DF
DF lifted up
Ringing signal detected
NCU off hook (start of dialing)
Main Switch On
Ringing signal detected
NCU off hook (start of dialing)
Auto Shut Off Timer
Main Switch Off
2-68
Auto Energy Saver Mode
Energy Saver Level 1 or 2
Fusing lamp: Low temp.
Energy Saver LED On
SCP On (System 5V On)
Energy Saver CPU On
(5VE On)
Auto Shut Off
Timer
Auto Energy Saver Mode
Energy Saver Level 4
Fusing Lamp Off
Energy Saver LED On
SCP Off (System 5V Off)
Energy Saver CPU On
(5VE On)
Main
Switch
Off
Night Mode Level 2
Fusing Lamp Off
Energy Saver LED Off
SCP Off (System 5V Off)
Energy Saver CPU On
(5VE On)
A193D549.wmf
SM