Gestetner A193 Service Manual page 701

A639 ROM MODIFICATION HISTORY
DESCRIPTI39ON OF MODIFICATION
Version A & B were for the pre-production
machines
Corrects the following:
- If the G3 Reception(analog port) and the iG3
Transmission (digital port) have a conflict, the
LED of the communicating turns on and is
locked.
- When the operator pick up the handset and
dial by using a quick or a speed dial then
hang up the handset during dialing, the
display always shows "Handset Mode". 1
or
When the handset is hung on and up within 1
second after pressing Start key
in the non-memory Tx mode, the display
always shows "Handset Mode". 1
If the operator performs the transmit operation
or presses the Stop key, the display was
locked.
*If the handset is hung on and up under 1
condition,The display is not locked.
- When the ringing signal comes when going
into the night mode, the machine goes into
the night mode and goes back to Ready then
the power failure report is printed out. (The
file no. and communication mode on
JOURNAL are wrong.)
- New User Switch for the Forwarding
UserSw 0E(SW14)
bit5 : 0 - Off (Default)
1 - On *All received files are
forwarded
to the transfer address.
*On the user parameter list, the following
description is not printed. "Forwarding all
received files ON/OFF"
- In the date input mode, the display shows
"24hr format" instead of "12hr format".
- The download and upload function from
FCU board to FCU board with the feature
card do not work.
Corrects the following:
- When the handset is picked up at detecting
of ringing signal, the reception is
disconnected and the reception job is rarely
remaining internally. In this case, the display
is not going to the "Handset Mode" even if the
handset is picked up. Or the "line is busy" is
displayed at the direct tx by ADF.
SM
(Fax Section)
RICOH P/N QTY SERIAL
NUMBER
A1945581 C 1 1st Mass
Production
A1945581 D 1 November '96
A1945581 E 1 December '96
6-9
REV. 05/98
LOCATION
Continued...
(A639)