Gestetner A193 Service Manual page 559

Table of Contents

Advertisement

In the following cases, the machine uses normal memory transmission even if
parallel memory transmission is enabled.
Send later transmission
Broadcasting
Transmission of an Auto Document only
Transfer request transmission
When Image Rotation before Tx is enabled, and an A4 sideways or
8.5 x 11" sideways original is detected
If the other terminal is busy
If the external telephone connected to the machine is in use
When communication switch 0A, bit 0 is set to 1, and the machine is
using memory transmission when redialing
When remaining memory space is less than the threshold for parallel
memory transmission (default = 512 kB)
When the original is located on the exposure glass
When using G4 transmission, parallel memory transmission is normally
disabled, because transmission using G4 is much faster than scanning. As a
result, G4 transmission using parallel memory transmission takes about twice
as long as normal memory transmission (using an ITU-T #1 test chart).
If the document contains pages with complicated images or it is a photo
document using halftone, parallel memory transmission may be faster than
normal memory transmission. If the user commonly sends this type of fax
message, enable parallel memory transmission for G4 transmission by
changing system switch 11, bit 7 to 1.
Cross Reference
Parallel memory tx (G3) On/Off
Parallel memory tx (G4) On/Off
Memory threshold for enabling parallel memory tx
Point of resumption of memory transmission upon redialing
(A639)
PARALLEL MEMORY TRANSMISSION
- User parameter 07, bit 2
- System switch 11, bit 7
- System switch 10, bits 0 to 7
- Communication switch 0A, bit 0
2-5
SM

Advertisement

Table of Contents
loading

This manual is also suitable for:

A224

Table of Contents