Table of Contents
Advertisement
2.3 PRINTER SWITCHES
Printer Switch 00
No
FUNCTION
0 Page separation mark
0: Disabled
1: Enabled
1 Repetition of data when the
received page is longer than
the printer paper
0: Disabled 1: Enabled
2 Prints date and time data on
received fax messages
0: Disabled 1: Enabled
3-6 Not used
7 mm-inch recognition when
printing
0: Disabled 1: Enabled
Printer Switch 01
No
FUNCTION
0
Not used
1
2
3
Maximum print width used in the setup protocol.
4
= Not used ,
0
1
0
0
5
Not used
6
7 Received message width
restriction in the protocol
signal to the sender
0: Disabled
1: Enabled
(A639)
0: No marks are printed.
1: If a received page has to be printed out on two
sheets, an asterisk inside square brackets is printed at
the bottom right hand corner of the first sheet, and a "2"
inside a small box is printed at the top right hand corner
of the second sheet. This helps the user to identify
pages that have been split.
0: The next page continues from where the previous
page left off.
1: The final few mm of the previous page are printed at
the top of the next page.
See Sub Scan Reduction and Page Separation in
section 2 for details.
This switch is only effective when user parameter 02 -
bit 2 (printing the received date and time on received fax
messages) is enabled.
1: The machine prints received and printed date and
time at the bottom of each received page.
Do not change the settings.
0: Printing is always done in inch format.
1: The machine switches the print resolution unit in
accordance with the resolution unit of the received data,
which has been specified in the setup protocol.
Refer to Sub Scan Reduction and Page Separation in
section 2 for details.
Do not change the settings.
,
0
297 mm
254 mm
=
=
10.1 inch
11.7 inch
1
Do not change the settings.
0: The machine informs the transmitting machine of the
print width depending on the paper size available from
the paper feed stations.
Refer to the table on the next page for how the machine
chooses the paper width used in the setup protocol
(NSF/DIS).
1: The machine informs the transmitting machine of the
fixed paper width which is specified by bits 3 and 4 above.
4-35
COMMENTS
COMMENTS
,
1
216 mm
=
1
8.5 inch
BIT SWITCHES
SM
Advertisement
Chapters
Table of Contents
