Gestetner A193 Service Manual page 163

COPIER INSTALLATION
[G]
4. Install 3 clamps [D]
5. Install the interface board [E], and connect the tray heater harness [F] to
the interface board. Then, clamp the harness as shown in the illustration.
6. Connect the interface harness [G] to the motor [H] and the interface
board.
7. Reassemble the machine.
8. Check the printer side-to-side registration (3rd and 4th tray).
NOTE: Instruct the customer that even when the copier's main switch is
turned off, the copier power cord should be plugged in.
Otherwise, the tray heater will not function.
(A193)
[H]
[E]
3-24
[F]
[D]
A193I509.wmf
SM