Gestetner A193 Service Manual page 562

TRANSFER BROADCASTING
When programming the machine to act as a Transfer Station, the
combination of the communication switch 0C setting (number of digits) and
the programmed location of the requester's fax number has to be considered
carefully.
If the machine can not find the destination for the report, it either:
Stops the transfer operation and prints a report locally (if bit 5 of
•
communication switch 0B is 0).
Or, continues the transfer operation and prints a result report locally after
•
finishing all the transfer operations (if bit 5 of communication switch 0B is
1).
Cross Reference to other parameters
ID code programming
Use of economy transmission during a transfer operation to end receivers
Use of economy transmission during a transfer operation to next transfer
stations
Use of label insertion for the end receivers in a transfer operation
Printout of the message when acting as a transfer station
SM
- Key operator mode
- Communication switch 0B, bit 0
- Communication switch 0B, bit 1
- Communication switch 0B, bit 2
- Communication switch 0B, bit 4
2-8 (A639)