Gestetner A193 Service Manual page 638

BIT SWITCHES
Scanner Switch 0E
No FUNCTION
0 Wait time for the next page
when scanning a book
original into memory
0: 60 seconds
1: 30 seconds
1 Scan resolution unit
(except standard resolution in
book scan mode)
0: mm
1: inch
2 ADF jam alarm display time
0: 60 s
1: 30 s
3 Scan resolution unit
(standard resolution in book
scan mode)
0: mm
1: inch
4 Not used
to
7
Scanner Switch 0F
No FUNCTION
0 Image rotation before
transmission
0: Enabled
1: Disabled
1 Not used
to
7
SM
This bit determines how long the machine waits for the
next page when scanning a book original for memory
transmission. If this timer expires, the machine transmits
all the pages scanned so far as one document.
Note: In immediate tx, the wait time for the next page is
15 seconds.
This bit determines which resolution unit will be used for
scanning a fax message.
Default setting: mm
The bit is only effective when bit 0 of scanner bit switch
0C is '0'.
This bit determines how long the machine displays the
ADF jam alarm after a jam has happened.
This bit determines which resolution unit will be used for
scanning a fax message, when standard resolution is
selected in book scan mode.
Default setting: inch
Do not change the settings.
This bit determines whether the machine rotates the
scanned image by 90 degrees before transmission.
If this bit is set at 0, A4 (LT) sideways images (297 mm
width in the protocol) will be transmitted as A4 (LT)
lengthwise images (216 mm width in the protocol).
Refer to Image Rotation Before Transmission in chapter
2 for more details.
Do not change the settings.
4-34
COMMENTS
COMMENTS
(A639)