Gestetner A193 Service Manual page 647

Communication Switch 08 - Not used (do not change the settings.)
Communication Switch 09 - Not used (do not change the settings)
Communication Switch 0A
No FUNCTION
0 Point of resumption of
memory transmission upon
redialing
0: From the error page
1: From page 1
1 Not used
to
6
7 Emergency calls using 999
0: Enabled 1: Disabled
Communication Switch 0B
No FUNCTION
0 Use of Economy
Transmission during a
Transfer operation to end
receivers
0: Disabled 1: Enabled
1 Use of Economy
Transmission during a
Transfer operation to the
Next Transfer Stations
0: Disabled 1: Enabled
2 Use of Label Insertion for the
End Receivers in a Transfer
operation
0: Disabled 1: Enabled
3 Conditions required for
Transfer Result Report
transmission
0: Always transmitted
1: Only transmitted if there
was an error
4 Printout of the message
when acting as a Transfer
Station
0: Disabled 1: Enabled
(A639)
COMMENTS
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page, using normal
memory transmission.
Do not change the settings.
If this bit is at 1, the machine will not allow you to dial
999 at the auto-dialer. This is a PTT requirement in the
UK and some other countries.
COMMENTS
These bits determine whether the machine uses the
Economy Transmission feature when it is carrying out a
Transfer operation as a Transfer Station.
This bit determines whether the machine uses the Label
Insertion feature when it is carrying out a Transfer
operation as a Transfer Station.
0: When acting as a Transfer Station, the machine will
always send a Transfer Result Report back to the
Requesting Station after completing the Transfer
Request, even if there were no problems.
1: The machine will only send back a Transfer Result
Report if there were errors during communication so
that one or more of the End Receivers could not be
contacted.
When the machine is acting as a Transfer Station, this
bit determines whether the machine prints the fax
message coming in from the Requesting Terminal.
4-43
BIT SWITCHES
SM