Programming Procedure - Gestetner A193 Service Manual

4. DEDICATED TRANSMISSION PARAMETERS
Each Quick Dial Key and Speed Dial Code has four bytes of programmable
parameters allocated to it. If transmissions to a particular machine often
experience problems, store that terminal's fax number as a Quick Dial or
Speed Dial, and adjust the parameters allocated to that number.
The programming procedure will be explained first. Then, the four bytes will
be described.

4.1 PROGRAMMING PROCEDURE

1. Make sure the machine is in 'Facsimile' mode. Press 'User Tools' key
then choose 'Fax'.
2. Press '1', then either choose 'Registering Quick Dial' or 'Registering
Speed Dial'.
Example: Change the Parameters in Quick Dial 10.
4. Press Quick Dial key 10.
Note: The selected Quick or Speed Dial must be programmed
beforehand.
5. When the programmed dial number is displayed, press the letters S - V -
C using Quick Dial keys, then press 'Start'.
6. The settings for byte 0 are now displayed. Press a number from 0 to 7
corresponding to the bit that you wish to change.
Example: Change bit 7 to 1: Press 7
7. To scroll through the parameter bytes, either:
Select the next byte: press '↓ Switch'
or
Select the previous byte: press '↑ Switch'
until the correct byte is displayed. Then go back to step 6.
8. After the setting is changed, press OK.
9. To finish, press 'User Tools'.
(A639)
DEDICATED TRANSMISSION PARAMETERS
4-63 SM