Gestetner A193 Service Manual page 702

A639 ROM MODIFICATION HISTORY
DESCRIPTION OF MODIFICATION
Corrects the following:
- In manual tx mode by the handset, the
operator presses the Start key and hangs up
the handset at the same time. The
transmission job is then remaining internally.
In this case, neither transmission or reception
are available and/or the "Handset mode" is
always displayed. This problem can be
solved by picking up and hanging up the
handset again.
- The chain dial function is not used by the
on-hook or handset mode.
- When the machine stores a letter size
original by using image rotation, the
compression does not succeed and the job is
reset if the original is a complicated image
which is scanned in photo mode.
- After entering the personal code and going
to the fax mode in the personal code
transmission mode, if the programmed key
(Quick dial) is used, the personal code is not
printed on the JOURNAL report.
- New Bit Switches are added for some
reports.
System SW 1F-Bit1 :
When the memory over flow or the
storing jam occurs, the Memory Storage
Report
and the Memory Transmission Report
are not printed out.
0:OFF(Default)-Print
User SW 03-Bit2 :
Memory Storage Report is printed
automatically.
0:OFF(Default)
System SW 1E-Bit1 :
The condition of the eracing the file at
full-memory
0:Only a page is eraced
1:The file is eraced.
*The combination of the above bit switches;
User SW 03: OFF
System SW 1F: OFF
Memory Storage OK X
Memory Storage NG
O
Continuing after the
O
memory full
(by SysSW 1E-Bit1)
O = Memory Storage Report is printed out.
(A639)
RICOH P/N
A1945581 E
1:ON-No print
1:ON-Print
ON OFF ON
OFF ON ON
O X O
O X X
O X X
6-10
(Fax Section)
QTY SERIAL
NUMBER
1 December '96
REV. 05/98
LOCATION
SM