Service Program Mode Table - Gestetner A193 Service Manual

SERVICE PROGRAM MODE TABLE

12. SERVICE PROGRAM MODE TABLE
12.1 MAIN SP MODE TABLE
NOTE: 1) A "#" mark after the mode number indicates that this SP mode is
only used for the A193 machine.
2) A "##" mark after the mode number indicates that this SP mode is
only used for the A224 machine.
3) In the Function column, comments are in italics.
4) In the Settings column, the default value is in bold letters.
5) An asterisk ( * ) after the mode number indicates that this mode is
stored in the NVRAM. If the RAM is reset, all these SP modes will
return to their factory settings.
Mode No.
Class
Class 3
1 and 2
Leading Edge
Registration
(Normal
1 copying, and
duplex 1st
side)
1-001 *
Leading Edge
Registration
(Duplex: 2nd
side)
2
Side-to-Side
Registration
(1st paper
feed)
1 #
1-002 *
Side-to-Side
Registration
(2nd paper
2
feed)
A224
Function
Adjusts the printing leading edge
registration using the Trimming Area
Pattern (SP5-902, No.10).
Use the •/∗ key to toggle between + and -.
The specification is 3 ± 2 mm. See
"Replacement and Adjustment - Copy
Image Adjustments" for details.
Adjusts the printing leading edge
registration using the Trimming Area
Pattern (SP5-902, No.10).
Use the •/∗ key to toggle between + and -.
The specification is 3 ± 2 mm. See
"Replacement and Adjustment - Copy
Image Adjustments" for details.
Adjusts the printing side-to-side
registration from the 1st paper feed
station using the Trimming Area Pattern
(SP5-902, No.10).
Use the •/∗ key to toggle between + and -.
The specification is 2 ± 1.5 mm. See
"Replacement and Adjustment - Copy
Image Adjustments" for details.
Adjusts the printing side-to-side
registration from the 2nd paper feed
station using the Trimming Area Pattern
(SP5-902, No.10).
Use the •/∗ key to toggle between + and -.
The specification is 2 ± 1.5 mm.
13-20
Settings
+9 ~ -9
0.1 mm/step
+ 0.0 mm
+12.5 ~ -12.5
0.1 mm/step
+ 0.0 mm
+9 ~ -9
0.1 mm/step
+ 0.0 mm
+9 ~ -9
1 mm/step
+ 0.0 mm
SM