Drive – Tray 1, Tray 2, And By-Pass Tray - Gestetner B147 Service Manual

6.9.2 DRIVE – TRAY 1, TRAY 2, AND BY-PASS TRAY
[E]
[H]
[I]
[J]
[K]
[L]
[M]
B146D544.WMF
The paper feed motor [A] drives the pick-up and feed mechanisms in tray 1 [E], tray
2 [F], and the by-pass tray [G], using clutches and complex trains of gears (the
locations of the gear trains are indicated by dotted lines in the above diagram).
When tray 1 and tray 2 are inside the machine, their pick-up rollers [H][K] are
always in contact with each top sheet of the paper stack. On the other hand, the
pick-up roller [P] of the by-pass tray stays away until the by-pass pick-up solenoid
[Q] turns on. When the paper feed clutch [B][C][D] turns on, the pick-up, feed
[I][L][N], and separation [J][M][O] rollers start rotating to feed the paper. The paper
feed clutch stays on until shortly after the registration sensor activates.
SM
[B]
[F]
[G]
[N]
[O]
[P]
6-67
PAPER FEED
[A]
[C]
[D]
B146D545.WMF
B147/B149/B190
[Q]