Automatic Service Calls - Gestetner A193 Service Manual

1. AUTOMATIC SERVICE CALLS

1.1 SERVICE CALL CONDITIONS
The fax unit makes an automatic service call when an SC code, other than
the following, is informed from the base copier's BiCU.
Note
The service station's fax number has to be programmed in
advance, for the machine to make a service call.
Exceptions
Address (H)
49FB64 1st SC code - High byte (BCD)
49FB65 1st SC code - Low byte (BCD)
49FB66 2nd SC code - High byte (BCD)
49FB67 2nd SC code - Low byte (BCD)
49FB68 3rd SC code - High byte (BCD)
49FB69 3rd SC code - Low byte (BCD)
49FB6A 4th SC code - High byte (BCD)
49FB6B 4th SC code - Low byte (BCD)
49FB6C 5th SC code - High byte (BCD)
49FB6D 5th SC code - Low byte (BCD)
49FB6E 6th SC code - High byte (BCD)
49FB6F 6th SC code - Low byte (BCD)
49FB70 7th SC code - High byte (BCD)
49FB71 7th SC code - Low byte (BCD)
49FB72 8th SC code - High byte (BCD)
49FB73 8th SC code - Low byte (BCD)
49FB74 9th SC code - High byte (BCD)
49FB75 9th SC code - Low byte (BCD)
49FB76 10th SC code - High byte (BCD)
49FB77 10th SC code - Low byte (BCD)
To add additional SC codes, program them in the blank addresses.
The fax unit cannot make an automatic service call when a Fax SC code
condition has occurred. Refer to Troubleshooting for Fax SC code details.
Manual Service Call
If the service station needs a report, the user can make a service call
manually, by setting bit 7 of User Parameter 14 (0E) to '1'.
(A639)
Definition
2-1
AUTOMATIC SERVICE CALLS
Default SC code
01 192
SBU adjustment error
92
01 193
APS sensor error
93
03 390
TD sensor error 1
90
03 393
TD sensor error 2
93
06 691
BiCU/FCU
91
communication error
09 980
BiCU program load error
80
FF Not programmed
FF
FF Not programmed
FF
FF Not programmed
FF
FF Not programmed
FF
SM