Copier Only - Gestetner A193 Service Manual

ENERGY SAVER MODES

8.2 COPIER ONLY

Stand-by Mode
Entering energy saver mode
The machine enters energy saver level 1 or 2 when one of the following is
detected.
•
The system auto reset timer runs out.
•
The Clear Mode/Energy Saver key is held down for over 1 seconds
What happens in energy saver modes 1 and 2
When the machine enters energy saver level 1 or 2, the fusing lamp drops to
a preset temperature, depending on the energy saver level selected (UP
mode).
The fusing temperature for energy saver level 1 is 15°C below the fusing
lamp operating temperature, which is set by SP1-105-1 (default: 180 - 15 =
165°C). The fusing temperature for energy saver level 2 is the value set by
SP1-105-2 (default: 140°C for 115V machines, room temperature for 230V
machines).
When the auto shut off timer runs out
The auto shut off timer starts when the machine enters standby mode.
When this timer runs out, the machine enters auto shut off mode and the
main switch turns off automatically. The fusing lamp and all dc supplies
except +5VE turn off.
(A193)
Clear Mode/Energy Saver Key
System Auto Reset Timer
Clear Mode/Energy Saver Key
Original in the DF
DF lifted up
Main Switch Off
Main Switch On
2-64
Auto Energy Saver Mode
Energy Saver Level 1 or 2
Fusing lamp to low temperature
Energy Saver LED On
C P U / G A P D O n
Auto Shut Off Timer
Auto Shut Off Mode
Fusing Lamp Off
Energy Saver LED Off
C P U / G A P D O f f
A193D547.wmf
SM