Hard Disk - Gestetner A193 Service Manual

HARD DISK

3. HARD DISK
3.1 INSTALLATION PROCEDURE
NOTE: If the fax unit is already installed, remove the fax unit before
attempting to install the hard disk. Refer to "Removal and
Replacement," later in this chapter.

CAUTION
1. Before installing an optional unit, perform the following:
1) Print out all messages stored in the memory.
2) Print out the lists of user-programmed items and the system parameter list.
3) Switch off the main and ac switches, and disconnect the power
cord and the telephone cord.
2. The hard disk interface card contains a lithium battery. The danger
of explosion exists if a battery of this type is incorrectly replaced.
Replace only with the same or an equivalent type recommended by
the manufacturer. Discard used batteries in accordance with the
manufacturer's instructions.
[A]
[B]
[E]
1. Attach the bracket [A] to the hard disk drive [B] (4 screws).
2. Attach the hard disk drive assembly [C] to the fax unit (2 screws).
3. Connect one end of the hard disk cable [D] to the hard disk drive, as
shown, and run the other end [E] through the opening [F].
4. Turn on the battery switch [G] on the hard disk interface card [H].
SM
[C]
[F]
A194I507.wmf
3-10
[D]
[I]
[E]
[G]
[H]
A194I508.wmf
(A639)