Configuring Key Vault Settings For Ibm Tivoli Key Lifetime Manager; (Tklm) - Brocade Communications Systems Brocade 8/12c User Manual

14. Click Next.
FIGURE 205
15. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
16. Click Finish to exit the Configure Switch Encryption wizard.
17. Review

Configuring key vault settings for IBM Tivoli Key Lifetime Manager

(TKLM)

The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 474.
Figure 206
Brocade Network Advisor SAN User Manual
53-1002167-01
All configuration items have green check marks if the configuration is successful. A red stop
sign indicates a failed step. A message displays below the table, indicating the encryption
switch was added to the group you named, and the public key certificate is stored in the
location you specified.
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
results" on page 503 for more information.
The Next Steps dialog box displays
certificates for the encryption switch are displayed.
Next Steps dialog box
"Understanding configuration status results"
shows the key vault selection dialog box for TKLM.
Creating a new encryption group
"Understanding configuration status
(Figure 205). Instructions for installing public key
on page 503.
"Creating a new encryption group"
18
497